Apache Technologies Bullseye 3 Manuale dell'Operatore Scaricare il pdf (Pagina 9)

Operation

Deadband (Accuracy) Selection. The deadband, or on-grade

accuracy, can be changed to meet various job conditions. To

identify which mode is selected, press the deadband selection

switch once. The current selection LED is activated. To change

the deadband, press the deadband selection switch again when the

deadband LED is activated. The deadband and corresponding LED will

change with each press.

Brightness Selection. The brightness switch controls the

LED display brightness. Bright and Dim are the selection

options. Use Bright for daytime operation if necessary and

Dim for lower light conditions. Display Dim will extend battery life by

approximately 50%.

When the brightness switch is pressed and the receiver is out of the

laser beam, the LED's will display a circle with the current setting. Press

the brightness switch again while the LED's are activated to change

the setting. The LED's will then display the new setting.

When the receiver is in the laser beam, simply press the brightness

switch and the setting will change.

Fine

Deadband

~ 3/16"

(0.20"/5mm)

Standard

Deadband

~ 1/2"

(0.45"/12mm)

Wide

Deadband

1-1/4"

(1.25"/32mm)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Nessun commento

Apache Technologies Bullseye 3 Manuale dell'Operatore Pagina 9